800-472-3741              $249.50 (Wholesale)        


Home Inspection/Foundation Repair

Olmsted Lock & Dam Project

 Manufactured/Modular
Housing Setup		 General Construction To Order
For More Information or
Your Nearest Distributor		 Troubleshooting

Satisfied Customers & Associations
  • Troubleshooting:

     If you have a problem it is almost always one of two things:
  1. Air bubbles trapped in the line will cause slight variations. The larger the bubble the more the variation. A bubble 1/4" or smaller (about the size of a pencil eraser) will generally not cause a noticeable problem. Larger bubbles should be bled out, see page 2.

  2. Check the reservoir for the proper fluid level. If the reservoir is low, too full or has too much air trapped in it the readings will not hold steady. The reservoir should be between 1/3 and 2/3 full for ideal operation. You must fill the reservoir completely full, then bled approximately 200 drops back out to give the diaphragm room to expand, see page 2

     If after checking these two things your problem persists, call 800-472-3741 for technical assistance.

To completely flush the system: If too much air becomes trapped in the line or near the middle of the tubing, the complete system can be flushed by:
  1. Fully unwind tubing.
  2. Pull the reservoir out from the reel 4 to 5 feet.
  3. Remove the reservoir cover and filler plug.
  4. Completely submerge the reservoir in a pail or bucket of RV anti-freeze, with the plug hole facing up, with the pail 4 to 5 feet higher than the display.
  5. Remove the bleed plug from the display and allow anti-freeze to siphon through the system as you would with a regular water level, (you may have to raise the reservoir higher to start the siphon).
  6. When all of the air has been flushed out replace the bleed plug in the display and fill the reservoir as per page 2.
     Prices for individual replacement components are as follows:

Display$129.50
Reservoir$29.50
Reel$37.50
Tubing$24.50
Splice kit$7.50
Diaphragm & O-ring set$10.00

                                                                                                  Plus $7.50 Shipping



  • Warranty:

     The warranty policy regarding Digital Leveling Systems electronic water level is as follows:

     Digital Leveling Systems warrants the electronic water level against defects in material or workmanship for a period of 90 days from the date of purchase. If a problem arises, the user is first instructed to contact DLS at 800-472-3741 for technical assistance. If it is then determined by DLS to be a possible problem with the level, the user will be instructed to return the level via UPS to DLS. Upon inspection DLS will, at our option, repair or replace any defective components as is warranted at our discretion.

     If the level is determined to be in proper working order, or damaged by the user, DLS will notify the user of any charges, before repairs are made or the level is returned.

     note: In some cases DLS may, at our option, repair or replace questionable components, during or beyond the 90 day period, at a reduced cost.

     There is a minimum $35 service charge on levels not covered under warranty.


Copyright © 2008 Digital Leveling Systems